Removal Spring Steel Pre-Applied PEI Flex Plate+Magnetic Base 3D Printer Hot bed

Description

New Upgrade Removal Spring Steel Sheet Pre-applied PEI+Magnetic Base 165/203/220/224/235/310mm for 3D Printer Hot Bed
We are  the first one who sells PEI sheets and spring steel sheet as the 3d printer surface in China.  is using one very special spring steel sheet what is never rust and always flat, the quality is superb not like other sellers who is using poor quality material what is not flat and curved when heating.
Donrsquot earn regrets for just saving seveal bucks as you can see other sellers are coping our flexplate even stole the description from our store directly.
Items Included:
Spring Steel Sheet pre-applied PEI Sheet+Magnetic Rubber Plate
the magnetic base can stand the high temp at 140C without losing magnetism, suitable for almost all filaments.  PLA, ABS, PC, etc
Advtanges:
Never warp& Never rust.
Easy to get the first layer even for a new user
Flexible, Removable, stick to magnets very well
Suits variety of filaments, especially for PLA
Free clean- just flex the plate a little then take the prints off after cooled
Fast heater performance, less waiting time after printing.
A lifetime 3D printer bed
Why our price is higher?
1. smooth
PEI- 0.2MM thickness with 3M468 tape
2.Our spring steel sheet is flat.
3.
Strong magnetic base: 1.5MM, 300LSE tape,  magnetism-600GS  high temp resist up to 130C at long time
Material:
100% real Ultem1000（ PEI）amber color, matte surface. - Made in Europe
This spring steel sheet is flat, flexible, stainless stick to magnets very well. 0.5mm or 0.4mm thickness
PEI is 3m tape pre-applied, free bubbles.
Important Information:
1.Recommend print temps
PLA – 60C
HTPLA – 60C
PETG – 70-80C
PCTG – 70-80C
ABS – 100C
2.Product Usage Guidelines
PETG/PCTG/TPU
– If you are not careful with your 1st layer you can risk bonding the PETG/PCTG/TPU to the PEI surface. This will damage the surface. To prevent damage to the surface apply hairspray or PVA gluestick before printing PETG/PCTG/TPU on the PEI
Part Removal
– Make sure your plate is at close to room temp (under 30C) before removing parts. If you remove when hot it more likely to damage the surface
How to use?
After apply the PEI sheet on our special spring stainless steel sheet, You can simply use 4 clips or magnets to hold it on the heatbed, then enjoy the printing.
Easily remove 3D prints on printer by removing the spring steel plate, flexing it, and popping the print off. It's simple and makes the print removal process much easier.
Aftersales:
If any quality problem, free returning.
Or send a message, we will reply you within 12 hours